Heads for pneumatic presses
Head type Type of die Terminals and connectors Cross section [mm2] Form of crimping PPH 11 equipped with dies according to […]
ERKO
SP 1 Steering system
Steering system for PP 8 and PP 19 pneumatic presses for control of crimping cycle accuracy. Electrical power: 230V AC Power: compressed air 0,5 ÷ […]
PP 19 Pneumatic press
Pneumatic press for: • ring, spade, pin tubular terminals, receptacles and tabs without insulation • ring, spade, pin tubular terminals, receptacles and tabs with insulation […]
PP 8 Pneumatic press
pp8_1 pp8_2 pp8_3 pp8_4 Pneumatic press for: • ring, spade, pin tubular terminals, receptacles and tabs without insulation • ring, spade, pin tubular terminals, receptacles […]
MSEPA wire sleeve in full insulation
MSEPA wire sleeve in full insulation-rys With polyamid insulation Thermal resistance: -55°C to +125°C Material: brass Insulation colours Nominal wire […]
ACL Bi-metallic connector
acl_rys Material: copper, aluminum Tubular part according to DIN 46267 Thermal resistance 350°C Cross section [mm2] Symbol s1 [mm] d1 […]
Special terminals and connectors
Special terminals and connectors 2 Special terminals and connectors 3 Special terminals and connectors 4 More than 30 years of ERKO experience in the electrical […]
ACB Bi-metalic terminal with pin
acb_rys Material: copper, aluminum Tubular Al part according to DIN 46267 part 2 Thermal resistance 350°C Cross section [mm2] […]
KCM-F Tight Cu terminal up to 36kV
kcm-f rys Dimensions as for KCM Range 25 ÷ 625 mm2
KCR-F Tubular Cu terminal up to 36kV
kcr_f_rys Dimensions as for KCR Range 25 ÷ 625 mm2